Perforated Vehicle Decals

Yes, your decal comes with an adhesive side that is protected by a backing when originally shipped. Removing it is much like peeling a sticker away from a sticker sheet. The easiest way to do so is to start in a corner to get it started. Once started gently peel away the backing to expose the adhesive side of the decal.

If the very thin backing is hard to find or remove then a piece of scotch tape can be used to help peel away the backing. Simply put the piece of scotch tape on corner of the backing with part of it sticking off the edge of the sign. Then use the piece of tape like a tab and pull the backing away.

Please be sure to remove the backing slowly and carefully so that you don’t unintentionally leave part of the backing on the sign.

For the installation of your perforated decal, water should not be used. Before installing your decal make sure to read through all the instructions.

The first step is to clean your window with water and allow it to air dry. Once it is dry you can remove the backing protecting the decal’s adhesive side. Make sure the decal doesn’t stick to itself once the backing is removed!

The next step is the initial application of the decal to the window. This should be done lightly and methodically so that as air bubbles or pockets arise the decal can be peeled away and reapplied as needed. The easiest way to accomplish this is to “tack” two of the corners of the decal into place. To tack the corners just gently press the decal against the window in the corners. This will allow you to then apply the rest of the decal working from one side of the decal to the other. Carefully peel it back and reapply as necessary. Using a flat edge such as a squeegee helps to apply the decal without air pockets arising.

Once the entire decal is in place it can be pressed more firmly onto the window to ensure that the adhesive fully sets in. As noted elsewhere, once the adhesive is fully active removing and repositioning your decal will not be possible.

Your decal should be washed regularly. To do so use a wet or damp cloth that is non-abrasive to gently wipe away any build up on the decal. This will help retain the transparency of the decal and the vibrancy of the printed design.

While your decal is installed you should not use power or pressure washers at home nor take your car through automatic/automated car washes. The power of both of these methods can be significant enough to cause the decal to start to peel away or to rip the decal right off the window.

To remove your decal simply pull the decal away from the window. A sharp edge that won’t damage the window itself can be used to help peel it away. Usually no residue will be left, but when the decal is aged or has been exposed to extreme conditions, some residue may be left behind. In these cases most standard cleaners and a scrubbing will remove it.

Difficult to remove decals come off easier when heated up. This can be accomplished by parking in the sun before removing it or even heating up the window with the car’s heat or a blow dryer. Though having to do either of the latter is rare and a last resort option for a decal that may have been in place for years.