Tension Fabric Stands

Setting up your tension stand does not require any additional tools and can be set up in less than 10 minutes. Your tension stand will come with a total of 8 poles, a solid metal stand, and the polyester display. Each pole part is labeled with numbers at either end (for example, a pole will have “2” at one end and a “3” at the other end). The “2” will match to another “2” and likewise with “3” matching up to another “3”.Begin assembling the sides of the frame by starting with the bottom vertical poles. These poles are unique in that they have plastic connectors on the side. One pull will be labeled with “1” and the other “6” at the end. Connect the “1” end with the pole with ends labeled “1 - 2,” with the “1” ends matching up. Then connect the “2 - 3” pole. This process will be repeated for the other side, with poles labeled “6 - 5” and “5 - 4” respectively. Once the sides are completed, attach them to the top pole of the frame, which is labeled “3 - 4”. Next, attach the cross pole to the plastic attaching points at the bottom of the frame. This pole is not labeled by numbers and can be attached to either end of the plastic connectors. Screw the pole onto the frame by tightening the plastic screw mechanism. Take care not to over tighten the screw, as doing so could break the connector pieces. Once the frame is assembled it’s time to place the display over it. Make sure the display is completely laid out before placing it on the frame. Carefully slip the fabric over the frame, making sure it does not snag or bunch up on itself. Place the completed frame and display onto the metal base plate using the snap buttons on the pole stubs of the base. These use the same button mechanism as the rest of the pole set. With the base attached to the frame, your tension stand is now ready for display.

The display portion of the tension stand can be machine washed on a low spin cycle setting using cold water. Do not use heavy detergents or bleach when washing the display. Allow the display to air dry after washing. Do not put the display in a tumble dryer, as using one will cause warping of the fabric and possible damaging of the printed design.

No need to use an Allen wrench to set up the tension banners. This is a plug-and-play setup process.

For the fabric banners, if disassembled in a box, the dimensions would be 11" x 4" x 38". Below are the measurements individually:

6 poles - 1" x 1" x 24"

1 pole - 1" x 1" x 20" & 1" x1" x 36"

T-pole - 8" x 8" x 1" 

Base - 8" x 10" x 0.5"